Call Us Today! 07956493233|sales@emcelite.com

Electrical Engineering

Generator coolers

Generator coolers

,

Electrical engineering of 6.6kv switchgear and testing of external devices.

415v Switchboards

415v Switchboards

Actuator, maintenance, setting of limits and checking feedback and positioning to provide accurate control parameters.

Retork A type actuator

Retork A type actuator

Our engineers can replace old A type actuators with the new I Q type actuators. They can set the limits on the actuators and find any faults back to DCS.

130 MW Rotor

130 MW Rotor

Our engineers carried out a careful strip down of a 130mw generator. The generator was carefully inspected and then received a major overhaul by our elite engineers.

6.6KV change over

6.6KV change over

This 6.6kv breaker would not automatically charge due to the mechanical mechanism not latching. Upon inspection by our engineer it transpired that this was due to combination of dirt and insufficient lubrication. It was removed, cleaned and repaired. Following which it was again re-inspected and fitted again, now correctly operating.

LP feed motor

LP feed motor

Bearing failure caused the motor to trip on overload. Due to the site not having a spare motor, EMC stripped the motor, replaced the defective bearings and replaced the lip seals. The motor was then rebuilt and thoroughly tested along with electrical tests and returned back in to service within 24 hours.

110v battery changeover system

110v battery changeover system

Faulty ABB circuit breakers prevented a mechanical latch so that the auto changeover would not operate correctly. The resolution was to remove and strip down the circuit breakers and lubricate the mechanical parts. These were then reinstalled and thoroughly checked for correct operation.

Electrical fault finding

Electrical fault finding

EMC electrical engineering response team reacting to electric field issues.